Manual

warning for the installer important - Please read carefully the instructions in this booklet and advice for proper installation. - The manufacturer disclaims any responsibility for any damage deirvanti from misuse and irrational appliance. - This appliance conforms to EEC Directive 87/308 on the suppression of radio interference size of the oven (see Fig. 1) size of the oven cavity (see Fig. 2-3) any furniture adjacent to the oven must withstand high temperatures or be protected by suitable materials Electrical connection of the oven this device must be installed by a qualified electrician familiar with the current safety standards and in accordance with the manufacturer's instructions. - Before connecting 1) ensure that the rated voltage of the electricity grid corresponds to that of the dwelling, shown on the rating plate signage. the plate (Fig. 4) and placed on the front right. 2. Make sure the power which must be operated in the kiln, either higher or at least sufficient competence in relation to maximum power absorption After installation, electrical parts should not be accessible. The technican is responsible for proper installation of the equipment and its conformita with local laws. - Ensure system efficiency grounded outlet pass current dwelling. the grounding of the appliance and obbilatoria to the law. For this reason, any plug socket used in addition to being capable;; 'absorption, must be the same type. - Install an organ break switch with contact opening distance equal to or greater than 3 mm, installed at not more than 2m from the apparatus... -If the oven is without a cable used to connect a power cable size H05 RR-F 3 * 2.5mm2. -Connect the cable to the plug. to connect the power cord to the terminal principlae the oven, follow these steps: Cut-sheathed power cable for about 60mm. Taking into account that the earth and the yellow / green, and that its length should be approximately 30mm larger than the cable line. Unsheathe-cable connection to about 8 mm -Remove the cover (A) (Figure 6) -Loosen the screws on the clamps (B) (Fig 7), and after threading the cable, tighten them thoroughly. Second-models, the oven and dated one of the two terminals represented in Figure 5-7 Connect-terminal connection to the terminal, follow the instructions of the diagram on the nameplate on the back of the oven (pluritensione) (Fig 7) - for undercounter oven, coupled with an electric piano, refer to the connection diagram on book (fig 5) -Connect the green / yellow wire to the ground terminal of terminal principlae, marked by the symbol - Replace the cover. -Connect the plug to the socket. Tips for installing the furnace - Because the furnace and a recessed, can only be used after installation into the cabinet, which must have the dimensions shown in Figure 2 or 3 leaving the rear of the cabinet ventilation opening as shown in Figure 2 or 3. installation of the column oven - Connect the power cord to the main terminal of the oven (as described under "electrical connection of the oven) - Place the oven in the unit not to lift the door handle but using 2 handles supplied with the oven inserting them into holes on the sides of the furnace, take care not to crush the wires of the electrical connection. - Lock the oven to the cabinet using four screws and spacers for (B) (fig 2) prone undercounter installation coupled with a electric hob - To stay and fix the electric piano as specified in its instruction manual. - Make connections of power cable to the terminal as described in the section "Connecting electric oven. Then make the ground connection between the cooktop and oven, part (A) Fig 8 - Then connect the terminals of the hob with the terminal located in the upper zone of the furnace (Figure 8) paying attention to correspondence from the references indicated in the colored plate. Stay-oven in the cavity, without lifting the door handle, and being careful not to crush Phyllis electrical connection. -Then block the oven to the cabinet using four screws and spacers for (part (B) fig. 2)