Strengt_Testing

Strengt Testing Compressive & Tensile Strength Testing OBJECTIVE Our purpose to determine some mechanical properties (compressive and tensile strength) of steel bar and concrete. 1- TENSILE STRENGTH TESTING INTRODUCTION There is as yet no standard test for directly determining tensile strength. However there are two common methods for estimating tensile strength through indirect tensile tests. The first, is the splitting test carried out on a standard cylinder specimen by applying a line load along the vertical diameter. It is not practical to apply the a true line load to the cylinder because the side are not smooth enough and because it would induced high compressive stresses at the surface. Therefore, a narrow loading strip made of soft material is used. Another way of estimating tensile strength is the flexural test. A specimen beam 6 x 6 x 20 inches is molds in two equal layers each rodded 60 times, once for each 2 in2 of top surface area. The beam may be vibrated and should be cured in the standard way. This test tends to overestimate the true tensile strength by about 50%. This can be explained by the fact that the simple flexural formula used is based on a linear stress-strain distribution whereas concrete has a strength, test, specimen, compressive, concrete, tensile, loading, testing, cylinder, area, should, load, steel, rate, mpa, kn, standard, made, machine, important, higher, 154, times, tested, surface, stress, stored, rodded, pmax, m2, diameter, because, bar, %